Envelope Punch Board Bow

Added by My Project Ideas Category : Papercrafting&gifts Difficulty : A Step Up (Medium)

Directions
You will need (2) 1”x 5” strip of DSP and (1) 1” x 6” Strip of DSP
- Using your Envelope Punch Board and your 1” x 5” strips of DSP, place your strip on 2-1/2” mark on the ruler and push the handle to create a punch out
- Turn that strip over and repeat
- Repeat this with your second 1”x 5” strip of DSP
- Next Flip the Envelope Punch Board and use the corner rounder for all four sides on both 1”x 5” strips of DSP

- Using your Envelope Punch Board and your 1” x 6” strips of DSP, place your strip on 3” mark on the ruler and push the handle to create a punch out
- Turn the strip over and repeat
- Next center the narrow side in Punch Board and push down
- Flip and repeat to create two tails
- Using your Bone Folder, break up the fibers in the (2) 1”x5” strips only
- Next Place Fast Fuse on the very end of the inside piece and adhere
- Be sure when using adhesive, you are working on your Craft Mat.
- Repeat that both 1”x 5” DSP strips
- Putting all the pieces together to create your bow…
 -Place Glue Dots on the back of each single bows & glue together
- Then Glue those pieces to strip with tails to create bow
- Place a Rhinestone in the center of a Vintage Faceted Buttons and Glue dots on the other side and adhere to center of bow


 

Rate Project
()
Add Comment