Washi Christmas Tree

Added by My Project Ideas Category : HandmadeCards Difficulty : In a Snap (Easy)

Create an A6 card blank from Very Vanilla cardstock (cut an A4 card down at 5 7/8 inches and fold in half).

Create a mat and layer with Pear Pizzazz (10cm x 14.5cm) and Very Vanilla (9.5cm x 14cm) cardstocks.

Create another mat and layer with Pear Pizzazz 7.5cm x 10cm) and Very Vanilla (7cm x 9.5cm) cardstocks.
 
Use the largest of the ‘Perfect Pines’ framelits dies to cut a tree out of the centre of the Very Vanilla cardstock.

Making sure the Very Vanilla and Pear Pizzazz layers are lined up, glue the die-cut tree to the Pear Pizzazz.

Using the ‘Season of Cheer’ washi tape, cover the tree in diagonal lines of tape.  Keep to the same repetitive pattern.

Using dimensional sticky pads, adhere the Very Vanilla frame to the Pear Pizzazz.  Glue this to the card blank created, little above centre.
  
Using a Cherry Cobbler ink, stamp a sentiment from the ‘Flurry of Wishes’ stamp set at the bottom of the card.

Using the ‘Itty Bitty’ punches, punch a star out of yellow cardstock and glue to the top of the tree.

Rate Project
()
Add Comment